XYZ Printing da Vinci Jr. WiFi Pro Quick Manual page 8

HOME AXES
"HOME AXES" moves the extruder to the lower left corner.
To home axes：
HOME AXES
ARE YOU SURE?
NO
YES
Select "YES" to proceed.
Z OFFSET
The user may use the Z OFFSET function to adjust the gap between the printing nozzle and the printing bed.
When adjusting the gap, use
[ ^ ]
Z OFFSET 0.91 mm
[ v ]
[ OK ] WHEN FINISH
After adjusting, press "OK" to exit.
JOG MODE
"JOG MODE" is used to manually move the extruder and the print bed.
Before you carry out this function, move the extruder module back to its original position (HOME AXIS).
How to move the extruder:
JOG MODE
X-AXIS
Y-AXIS
Z-AXIS
Select the direction of the module or the print bed to be moved.
1
Note:
"X-AXIS": left and right movement of the extruder module,
"Y-AXIS": front and back movement of the print bed,
"Z-AXIS": up and down movement of the extruder module.
BUILD FROM CARD
1 sample models are built into the printer. You may begin your first 3D prints with the samples.
To print a sample ：
BUILD (SD CARD)
SAMPLE
1 Select a sample
to print.
HD23FJPW1A7
HOME AXES
COMPLETED
[ OK ] TO RETURN
and keys to increase or decrease it (the minimum adjustment scale is 0.05mm).
Note:
The product has been tested and adjusted with
1
precision at factory. We suggest that you write down the
default Z OFFSET value before performing adjustment.
2
The recommended distance between the nozzle and
print bed(with bed tape securely fastened) is 0.3mm.
This should allow two sheets of copy paper to be drawn
out smoothly but six sheets of copy paper cannot be
passed.
2 Put the bed tape
on the print bed.
UTILITIES
Z-AXIS [ OK ] >> EXIT
[ － ] [ 0.1mm ]
1mm
10mm
2 Select desired increment of travel with
and buttons, and press
button for desired direction to move the extruder.
START BUILDING
SAMPLE
NO
YES
Select "YES" to
3
start printing.
da Vinci
[ ＋ ]
or
Remove the printed object when the
4
printing has finished and the print
bed has descended.The bed tape
is reusable and it can be replaced
when it's worn.
Jr. WiFi Pro
P 8