Steelcase Groupwork Flip-Top Table Assembly Replacement page 3

®
7.
Place each plate onto underside of worksurface and
align with pilot holes (7a). Attach each plate to worksurface
by first fastening two (2) #10 x 1-1/16" wood screws into the
pilot holes (7b). Insert ten (10) #10 x 1-1/16" wood screws
into remaining holes (7c).
NOTE: Protect top surface from scratches while working.
8.
Place each control lever bracket onto underside of
worksurface and align with pilot holes (8a). Mount each
bracket with two (2) #10 x 1-1/16" wood screws (8b). On 24" x 36"
table, cross control lever cables over each other (8c).
NOTE: Contact Steelcase if table doesn't have a linkage bar
(see page 1 for contact information).
RISK OF INJURY. The correct location of
leg mounting plates and control levers is
critical to the safe functioning of the table.
7b
7c
LINKAGE BAR
8b
A
PILOT HOLE LOCATIONS
B
7a
B
4.125
3.875
C
D
E
Wksf
A
Depth
24" 11.23
30" 8.375
8c
24" x 36" TABLE
A
B
8a
4.125
3.875
C
D
E
B C D E
7.2 8.73 19.0 20.0
10.2 5.875 14.75 15.75
7b
7c
Page 3 of 9
1075139001 Rev C
Wksf
Depth
B