Advertisement
Quick Links
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE
(888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A. Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
© 2002 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in the U.S.A.
Garland - Table Base Installation and Two-Piece Top Assembly
Round Table Top with a
Disk Base
Two-Piece Rectangular Top
with Panel Bases
IMPORTANT!
Before discarding packaging, please
ensure that all parts are included.
For Round Task Tables, please see
exploded view of assembly on page 2.
Power Driver
with Phillips tip
1/8" Drill Bit
1/2" Wrench
Level
Punch
- or-
3/32" Allen
Wrench
Page 1 of 5
Y9501757 Rev. M
Advertisement
Related Manuals for Steelcase Garland Round Table Top with a Disk Base
Summary of Contents for Steelcase Garland Round Table Top with a Disk Base
- Page 1 Disk Base Level Punch If you have a problem, question, or request, call - or- your local dealer, or Steelcase Line 1 at IMPORTANT! 888.STEELCASE (888.783.3522) Before discarding packaging, please for immediate action by people who want to help you.
- Page 2 Round Metal Base Installation Determine if you want the mousehole in the up or down position, then assemble base as shown. Mousehole may be positioned DOWN for wire management (top must have a port) Or... for no exposed detail. Page 2 of 5 Y9501757 Rev.M...
- Page 3 Carefully turn top over onto carpet or other soft, clean material. Locate and install base assembly. NOTE: If using a rectangular or square top, make sure base is mounted in a diagonal (3) screws per leg orientation (see above) to top. The drawing below shows the incorrect positioning of the base with top.
- Page 4 Panel Base Installation Align dowels with holes in top panel. Using holes in mounting bracket as guide, pilot drill (12) holes 1/8" Dowels (3.1mm) dia. and 1/2" (12.7mm) deep. Install (12) screws. Install support bracket with (5) 7/8" screws as shown. Repeat procedure for other base assembly.
- Page 5 Two-Piece Top Assembly Install splines into groove in one end of top section. Slide top halves together. Install (4) joint fasteners. Splines Tighten joint fasteners with punch or similar tool as shown. Refer to preceding page to install base assemblies. Page 5 of 5 Y9501757 Rev.
Need help?
Do you have a question about the Garland Round Table Top with a Disk Base and is the answer not in the manual?
Questions and answers