Table of Contents
Advertisement
2.9.2 Stereo Line Input Module Option Switches
The illustration below provides the locations of the Stereo Line Input Module internal option switches,
and defines their functions.
1 2 3 4 5 6 7 8
OPEN
O
1 2
N
Switch S7 sets whether the module's Direct Output follows the ON/OFF status of the module or has
continuous audio output.
Switch S200 is an eight-station switch that can enable muting of the Control Room, Studio-1 and
Studio-2 on the A and/or B inputs (typically only used when a preamplified microphone is connected
to the module). S200-4 and S200-8 separately enable the timer reset function for each input. When
closed the console timer resets at module ON.
PACIFIC RESEARCH & ENGINEERING
S7, Logic Assignment Selector
Function
C1 (Down): Direct Output follows module ON/OFF.
C2 (Up): Direct Output continuous.
S206, Logic Assignment Selector
Function
ON (CLOSED): Sends always active with PRE-fader
selection.
OFF (OPEN): Sends follow ON/OFF.
NOTE: Switch S206 is only present on modules equipped with
Sends.
S200, Logic Assignment Selector
#
Input
Function
1
ON (CLOSED): Control Room mute enable.
A
2
ON (CLOSED): Studio-1 mute enable.
A
3
ON (CLOSED): Studio-2 mute enable.
A
4
ON (CLOSED): Timer reset enable.
A
5
ON (CLOSED): Control Room mute enable.
B
6
ON (CLOSED): Studio-1 mute enable.
B
7
ON (CLOSED): Studio-2 mute enable.
B
8
ON (CLOSED): Timer reset enable.
B
S205, Logic Assignment Selector
#
Function
ON (CLOSED): CUE resets with module ON.
1
OFF (OPEN): No CUE reset function.
ON (CLOSED): SOLO resets with module ON.
2
OFF (OPEN): No SOLO reset function.
S207, Logic Assignment Selector
#
Input
Function
ON (CLOSED): No Ready lamp function.
1
A
OFF (OPEN): Ready lamp function enabled.
ON (CLOSED): No Ready lamp function.
2
B
OFF (OPEN): Ready lamp function enabled.
42
BMX SERIES III CONSOLE
REVISION C
Advertisement
Table of Contents
