Table of Contents
Advertisement
BMX SERIES III CONSOLE
2.3 MAINFRAME CONFIGURATION
Each BMX III mainframe is factory configured to the customer's order by the installation of microphone
input, line input and other modules in their specified and/or dedicated locations. This section contains
descriptions of the BMX III mainframe's control panel, meter panel and connector panel.
2.3.1 Control Panel
Figure 2.3 illustrates the control panel layout of an BMX III-14 console. The positions identified by
module names are dedicated to those modules only, and will not accept any other type of plug-in
module.
The positions indicated by shading are "optional", and blank panels will be installed in these positions
when no modules are present. Any unused "optional" module positions may be used for the installation
of customer designed special purpose panels. OPTION cutouts have been provided in the Molex
connector panel for the routing of wiring from these positions to the rear of the console (reference Figure
2.5).
NOTE: The "optional" module positions labeled A through E are pre-wired with 24-pin logic cables.
These cables are routed to corresponding rear panel OPTION cutouts, as defined in Figure 2.5.
A
B
C
D
E
INPUT MODULES 1 - 14
FIGURE 2.3 CONTROL PANEL LAYOUT
PACIFIC RESEARCH & ENGINEERING
REVISION C
10
Advertisement
Table of Contents
