Table of Contents
Advertisement
BMX SERIES III CONSOLE
2.3.3 Connector Panel
Figure 2.5 (on the following page) illustrates the Molex connector panel for an BMX III-14 console,
and is intended to provide the installer with a map to the location of the various groups of connectors
on the panel. As a general rule, the connectors for any given module are located on the panel behind
that module's position in the mainframe.
Cutouts are provided for a 24-pin Molex connector for each input position in the mainframe. These are
labeled "OPTION" and are available for the installation of remote control connectors, special purpose
panels, etc. The OPTION connectors labeled A through E on Figure 2.5 are pre-wired with 24-pin logic
cables, which are routed to corresponding positions in the mainframe, as defined in Figure 2.3.
Nylon tie anchors are provided along the length of the Molex connector panel for tying down patch
cables between the various module positions and the meter and monitor connectors. Factory configured
consoles will have the appropriate patch wiring in place.
NOTE: Audio and logic pin assignment information is provided in Figure 2.6 as a quick reference only.
It is highly recommended that the complete information contained in Section 2.7 be used when
connecting the console.
PACIFIC RESEARCH & ENGINEERING
REVISION C
12
Advertisement
Table of Contents
