Lucent Technologies Definity Callmaster II Instructions Manual page 36

To place an AD call
To program/reprogram an
outside number,
extension, or feature code
into a Personal List
Note: If the programmed number is associated with a
list, it can be up to 24 digits. If the stored number is
NOT associated with a list (that is, an Automatic
Dialing button), it can be up to 16 digits. See your
system manager if you need help.
6
Press #
The number is stored
7
Repeat Steps 4 through 6 to program additional
buttons
8
Hang up or press
1
Select an available call appearance button
2
Press the selected Abbreviated Dialing button
The call is dialed (silently)
1
On a separate sheet of paper, write down the outside
numbers, extensions, and/or feature codes you want
to program as items on your Personal List(s)
Note: Each phone number or feature code is stored
as a separate item.
2
Press a call appearance button
3
Press
Program
or Dial the Program access code ________ [dial tone]
4
Dial the Personal List number (1, 2, or 3)
5
Dial the list item (1, 2, 3...)
6
Dial the number you want to program (up to 24 digits)
Note: If you are programming an outside number,
be sure to include a trunk code, if applicable.
7 #
Press
The number is stored
Repeat Steps 5 through 7 if you want to program
additional items on the same list; press
and begin again at Step 1 if you want to program
items on another list.
[confirmation tone], then [dial tone]
to end programming
Release
[confirmation tone], then [dial tone]
[ringback tone]
[dial tone]
[dial tone]
Drop
32