Table of Contents
Advertisement
Checklist
Checklist
Frame
1.
Frame bolts (6x) are properly fixed.
2.
Frame profiles are perpendicular and propely aligned.
3.
Damping feet are placed underneath the printer.
X-axis
1.
X-axis rail is properly aligned.
2.
Bolts (2x) X-axis rail are properly fixed.
3.
X-axis belt pushed fully into bracket and tensioner.
4.
Belt remains at same height during moving the X-axis.
5.
Set screw (1x) for pulley is fixed at the correct height with set screw
6.
X-axis belt tensioned properly
Y-axis
1.
Bolts for stacked bearings (4x) guiding the belt are properly fixed
2.
Y-axis carriage is properly aligned in the Z-axis lift.
3.
Bolts (4x) of the Y-axis carriage are properly fixed.
4.
Y-axis belt pushed fully into bracket and tensioner.
5.
Belt remains at same height during moving the Y-axis.
6.
Set screw (1x) for pulley is fixed at the correct height with set screw
7.
Y-axis belt tensioned properly.
Z-axis
1.
Z-axis rail is properly aligned.
2.
Bolts (3x) Z-axis rail are properly fixed.
3.
Set screw (1x) Z-axis spindle is properly fixed.
4.
Bolts (4x) connecting Z-axis carriage to the lift are propely fixed
5.
Z-axis spindle nut is properly fitted in the Z-axis lift.
6.
Z-axis spindle is greased over its entire length.
FELIX TEC 4.1
Check
Build platform
1.
Bolt (1x) center of build platform is properly fixed.
2.
Build surface doesn't contain air bubbles.
Print head
1.
Extruder drive wheels properly aligned.
2.
Bolts (2x) connecting print head to X-axis carriage are properly fixed.
3.
Bolts (2x) sensor bracket are properly fixed.
Electrical
1.
Wire harness properly fixed without rubbing against parts.
2.
Wire harness loop for X, Y, Z-axis are at the correct length
3.
do not get pulled under full extension.
4.
Cables are not under tension and have enough slack.
5.
Cable ties neatly cut off.
6.
Connectors properly connected in sockets.
7.
Potentiometers on control board are set to the correct values.
8.
Control board contains the correct Tec 4 firmware version.
9.
Wire colors are according to diagram.
Online Tests
1.
Build platform heats up to 90 degrees C, move cable harness to
check for wire breakage.
2.
Extruders heat up to 90 degrees C, move cable harness to check for
wire breakage.
3.
Hot-ends don't move during loading/unloading filament.
4.
Check if filament gets pulled through firmly
Assembly Manual
34
30 November 2020
Check
www.FELIXprinters.com
Advertisement
Table of Contents
