Table of Contents
Advertisement
8.1.2 Control the Matrix Switcher from Remote
To control the matrix switcher from remote location, please connect one or more PCs to the RS-232 ports of
HDBaseT receivers with the 3-pin to DB9 RS-232 Cables. The matrix switcher can be controlled by any one of
PCs, the connection diagram is shown as below:
Note: The command "RS232RCM[X]ON." ([X]=0~8) needs to be sent to enable or disable this control mode.
For example, send the command "RS232RCM0ON." to enable the remote-control mode for all HDBaseT
outputs, and send the command "RS232RCM0OFF." to disable the remote-control mode for all HDBaseT
outputs. Please refer to the 8.3.1 System Control for more details.
8.1.3 Control the Remote Third-party Device from Local
To control a third-party device from local, first determine which HDBaseT receiver is connected to (1 in
the diagram below). Next, connect a PC to the corresponding RS-232 port of matrix switcher with 3-pin to
DB9 RS-232 Cable, then connect a third-party device (e.g. projector) to the RS-232 port of the determined
HDBaseT receiver. The remote third-party device can be controlled by the local PC, the connection diagram is
shown as below:
800.626.6445
29
Advertisement
Table of Contents
