6.4 RS-232 Tab
•
Send RS-232 commands to control third-party devices which are connected to the far-end HDBaseT
receivers
Select a built-in EDID for one or several input ports.
Operation:
1.
Select the HDBaseT port which is connected to HDBaseT receiver which must have third-party device
attached
2.
Set the baud rate
3.
Typing the commands in the box to control the selected remote third-party device which is connected to
HDBaseT receiver. If click the Hex, the RS-232 commands can be typed with hexadecimal value
4.
Click Send to transmit RS-232 command to the selected HDBaseT port
22
www.vanco1.com