Table of Contents
Advertisement
7.2.2 Control Remote Output Device from Local
The remote displays can be controlled from the local matrix switcher location.
•
Control remote device through IR IN port
Example: Switch HDMI input 3 to HDBaseT output 3.
Connect an IR receiver to IR IN 3 port on the matrix switcher, then connect an IR emitter to the IR OUT on the
receiver, as shown in the diagram below:
•
Control remote device through IR ALL IN port
The receiver can be connected to the IR ALL IN port on matrix switcher to control all remote output devices.
In this case, the IR emitter must be connected to the IR OUT port on each connected HDBaseT receiver, as
shown in the diagram below:
800.626.6445
27
Advertisement
Table of Contents
