Cleaning Non-Electronic Coin Drop - ALLIANCE BD3NGBGS303EW01 Original Instructions Manual

Adjustments
Silicon Carbide Ignition System
1. Air Shutter Lockscrew
2. Air Shutter
3. 1/8 inch Pipe Plug (For checking manifold pressure)
Figure 22
Silicon Nitride Ignition System
3
1. Air Shutter Lockscrew
2. Air Shutter
3. 1/8 inch Pipe Plug (For checking manifold pressure)
Figure 23

Cleaning Non-Electronic Coin Drop

1. Disconnect electrical power to machine and drop.
2. Remove coin drop from machine.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
1
2
D363SE3A_SVG
3. If lint is preventing coins from rolling through coin drop,
blow compressed air though coin entry and along the side of
the coin drop. Refer to Figure 24 .
1
1. Compressed Air
2. Cotter Pin
3. Metal Clip
4. Insert a coin through the coin drop. If coin does not roll
through drop, continue with the following.
5. Remove cotter pin from top of drop. Refer to Figure 24 . Save
pin for reinstallation when cleaning is complete.
6. Move metal clip closer to sensor so that it comes off frame.
Refer to Figure 24 .
7. Remove coin return from coin drop frame. Refer to Figure
25 .
1
1. Coin Return
2. Coin Drop Frame
8. Check coin path in coin drop for lint and esidue. If lint or
light residues are present, use a cotton swab to remove. If
heavy residue is present, it may be necessary to first scrape
off excessive residue and then use a cotton swab dipped in
water or isopropyl alcohol (rubbing alcohol) to remove re-
mainder of residue. Refer to Figure 26 .
66
2
3
DRY3B_SVG
Figure 24
2
DRY4B_SVG
Figure 25
Part No. D515519R3