Audiovox Pursuit PRO-9600 Owner's Manual page 8

3. Unlocking of the vehicle Doors; (Must have power door locks and optional interface in-
stalled). If you've ever locked your keys in your vehicle, this command requires no expla-
nation. A simple phone call to the 1-800 number and you're in.
4. Channel 2 / Auxiliary 1; Whatever function is controlled by the alarm's channel 2 can also
be activated by satellite paging. The function of auxiliary 1 is listed on your user's card as
well, indicated on the last page of this manual.
5. Channel 3 / Auxiliary 2; Whatever function is controlled by the alarm's channel 3 can also
be activated by satellite paging. The function of auxiliary 2 is listed on your user's card as
well, indicated on the last page of this manual.
6. Channel 4 / Auxiliary 3; Whatever function is controlled by the alarm's channel 4 can also
be activated by satellite paging. The function of auxiliary 3 is listed on your user's card as
well, indicated on the last page of this manual.
7. Theft / Carjack; If the vehicle has been stolen, or if the vehicle has been hijacked, you can
activate this command from any telephone. While in this mode, the vehicle lights and horn
/ siren will sound a specialized S.O.S. pattern, (3 short flashes and chirps, followed by 3
long flashes and chirps, followed by 3 short flashes and chirps...). In addition, the starter
inhibit feature is activated. This prevents restarting of the vehicle once it has been turned
off. In addition, the vehicle speed sensor is monitored and will allow the vehicle to be driven
a short distance. Once the vehicle comes to a complete stop for more than 5 seconds the
PRO-9600 will cause the engine to shut off, disabling the vehicle and leaving the thief
stranded. If the need arises to activate a theft command, the only way to reset this function
is to call in a "Reset" command. (see command 8 below)
8. Reset; While in the theft mode from a satellite command, reset will reset all light, siren,
and starter inhibit activity. After a reset command is issued, the vehicle doors will remain
locked. (Only with optional power door lock interface installed)
9. Test; This command allows you to confirm the operation of all of the paging features and
functions available to you. Upon request of the test command, the system will sequentially
test the features of your vehicle as follows:
Auxiliary 1, Auxiliary 2, Auxiliary 3, Unlock, Arm, Disarm, Theft, Reset.
NOTE: Do not leave keys in vehicle when requesting a test. Upon completion of the
test routine, the doors will lock.
NOTE: Auxiliary 1, 2, 3 if installed are listed later in this manual.
10. Auto Locate; This command allows you to locate your vehicle in a crowded parking lot.
Upon activation of this command, the vehicle's lights will flash and the horn/siren will sound
with a specialized S.O.S. pattern, (3 short flashes and chirps, followed by 3 long flashes
and chirps, followed by 3 short flashes and chirps). In addition, the starter inhibit feature
will be activated. This flash and chirp mode will remain active for 3 minutes after which,
only the lights will flash for an additional 2 minutes. The unit will then go into a sequenc-
ing of lights and siren for 30 seconds followed by lights only for 2 minutes followed by lights
and siren etc..... This mode will be reset by use of the arm/disarm button of your keychain
transmitter or by following the manual override sequence explained earlier in this manual.
8