Table of Contents
Advertisement
3 Button Remote Security System
FEATURES:
w 2 Three Button Programmable RF Transmitters
w Three Channel Receiver (capable of accepting 4 transmitters)
w Anti-scan Technology
w Remote Panic in all modes
w Protected Valet
w 7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming
w Intrusion Alert with Memory
w Audible Arm / Disarm / Defective Zone / Tamper Confirmation
w Instant Siren Activation
w Low Current Horn Output
w True Last Door Arming (hardwire only)
w Defective Zone By-Pass
w Hardwire or Voltage Sense Selectable
w Active or Passive Arming Selectable
w Programmable Auto Lock On / Off
w Programmable Auto Unlock On / Off
w Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
w Programmable Active or Passive Door Locks
w User Programmable Permanent Chirp Delete
w On Command RF Chirp Delete from Transmitter
w 6 Tone Multi-Tone Siren
w RF Inhibit with ignition on
w Parking Light Flasher
OPTIONS:
w Single or Dual Stage Shock Sensor
w Starter Disable
w Remote Trunk Release
w Remote Keyless Entry
w Multiple Vehicle Capable
w Remote Starter
w Remote Power Window Roll Up
w Remote Garage Door Interface
Model PRO-9642
Owner's Manual
Advertisement
Table of Contents
Related Manuals for Audiovox Pursuit PRO-9642
Summary of Contents for Audiovox Pursuit PRO-9642
- Page 1 Single or Dual Stage Shock Sensor w Starter Disable w Remote Trunk Release w Remote Keyless Entry w Multiple Vehicle Capable w Remote Starter w Remote Power Window Roll Up w Remote Garage Door Interface Model PRO-9642 Owner's Manual...
-
Page 2: Arming The System - Active
ARMING THE SYSTEM - ACTIVE 1. Turn off the engine, exit the vehicle and close all doors, hood lid, and trunk lid. 2. Press and release the Arm / Lock button on the keychain transmitter. þ Red dash mounted LED begins to flash slowly. þ... -
Page 3: Disarming The System
protected entry points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed and ignore that triggered zone. þ Whenever the system is armed, the red dash mounted LED indicator will slowly flash. This serves as a visual deterrent to the potential thief. -
Page 4: While The System Is Sounding
þ Parking Lights flash two times. If the parking lights flashed three times, then the alarm was triggered in your absence. Before turning the key on, examine the LED to identify which zone was triggered. þ Siren/Horn does not sound. If the siren and or horn sounds 4 chirps, then the alarm was triggered in your absence. -
Page 5: Manually Overriding Your System
3. To return to normal operation, press and release the pushbutton switch any time the ignition is on. NOTE : Always remember to return the system to the NON VALET mode after servicing to ensure that the vehicle remains protected at all times. MANUALLY OVERRIDING YOUR SYSTEM: USING THE VALET SWITCH MANUAL OVERRIDE Your Security System can be disarmed without the use of the keychain transmitter. - Page 6 NOTE: If 15 seconds of inactivity expire or if the ignition switch is turned off for more than 5 seconds during any of the above steps, the unit will revert back to the last success- fully stored code. Custom Code Programming Example: To Change the code from the factory pre-assigned code of 11 to “52”...
-
Page 7: Eliminating The Normal Arm / Disarm Chirps
NOTE: If the siren/horn chirps two times, regardless of the valet switch operation as described above, then the horn and siren chirps have been turned off via programming features 7 and 8. Contact your installation center or Audiovox technical department for information on how to reinstate the chirp feature through programming. -
Page 8: System Functions At A Glance
Auto Unlock with ignition key o Passive Arming o No Lock in passive mode o Hardwire doors, hood, and trunk o Siren Activation o Horn Activation © 2001 Audiovox Electronics Corporation, Hauppauge N.Y. 11788 PASSIVE ARMING ARMED DISARMED VALET MODE INTRUSION ZONE 3...