Audiovox Pursuit PRO-9600 Owner's Manual page 2

Your PRO-9600 Remote Security System with on-board Satellite/Paging Access has many
features and available options; some of which are selected at time of installation. For your
reference, the list on the back page of this manual shows what features and options have
been installed. Consult your installing dealer for options that may have been installed and
are not listed.
YOUR ANTI CODE GRABBING TRANSMITTERS:
The transmitters included with the PRO-9600 use technology considered to be the most
secure form of radio frequency transmission available on today's Automotive Security Sys-
tems. Thieves today may use a device commonly referred to as a code grabber. With this
device, the code transmitted from a common RF transmitter can be captured and played
back at a later date to disarm a standard security system. With the use of Anti Code Grab-
bing Technology, every time you activate your transmitter button, the code changes. This
changed code is now anticipated by the alarm and any prior code will no longer operate the
system. In this way, if a thief were to capture your code, it would be useless because your
alarm system is now looking for the next code in the transmitter's sequence.
If your transmitter is operated more than 50 times out of range of the alarm's receiver, (i.e.,
Children playing with your keys) the transmitter will not operate the alarm when you return to
the vehicle. The transmitter, in this situation, will have to be realigned. To realign your
transmitter, while within range of your alarm's receiver, simply press the transmitter's button
1 twice within one second. The system will now respond to that transmitter normally.
ARMING THE SYSTEM - ACTIVE OPERATION:
1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
2. Press and release the arm/disarm button of your key chain transmitter one time.
The parking lights will flash once, the siren will chirp once, and the dash mounted LED will
begin to flash slowly confirming the system is armed. If you have the optional door lock/
unlock circuit installed, the doors will lock.
Note: If the siren chirped three times, then you have left a door, hood, or trunk ajar. Simply
closing that opening will provide full protection. If the siren did not sound when arming,
then the chirps have been turned off. Refer to the section on "Eliminating the Arm/Disarm
Chirps" shown later in this manual.
SILENT ARMING - ACTIVE OPERATION:
1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
2. Press and hold the arm/disarm button of your key chain transmitter for two seconds.
The parking lights will flash once, and the dash mounted LED will begin to flash slowly
confirming the system is armed. The siren will not chirp. If you have the optional door
lock/unlock circuit installed, the doors will lock.
Note: If the siren chirped three times, then you have left a door, hood, or trunk ajar. Simply
closing that opening will provide full protection.
ARMING THE SYSTEM - PASSIVE OPERATION: (AUTOMATIC)
If the passive arming feature has been selected:
1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
The dash mounted LED will begin to flash rapidly indicating that the 30 second passive
arming timer has begun. If the LED does not begin to flash rapidly, then you have left a door,
hood, or trunk ajar. Closing this entry point will allow the arming cycle will begin. If any entry
2