Audiovox Pursuit PRO 9644a Owner's Manual
Audiovox Pursuit PRO 9644a Owner's Manual

Audiovox Pursuit PRO 9644a Owner's Manual

Pursuit series

Advertisement

Quick Links

3 Button Remote Security System with Starter Disable
IMPORTANT ! In order to provide the highest possible level of security to your vehicle, this
system is equipped with selectable manual override circuitry. It is possible that you will need to
manually override your security system if the transmitter becomes lost, or inoperative due to
battery failure. Reading the sections on "MANUALLY OVERRIDING YOUR SYSTEM" is
necessary to fully understand the procedure required to enable your vehicle in such situa-
tions. In addition, the chart on the last page of this manual has a section for the particular
features and options installed in your vehicle as well as the override method selected. Valet
Switch manual override is pre-selected from the factory, however, the system can be
configured for "Custom Code" operation. Confirm the override mode selected on the last page
of this manual and familiarize yourself with the section on it's operation.
FEATURES :
w 2 Three Button Programmable RF Transmitters (capable of accepting 4 transmitters)
w Separate Lock/Unlock Transmitter Buttons
w Five Channel Receiver
w Code Hopping Technology
w Selectable Manual Override Mode
w Remote Panic in all modes (Improved)
w Protected Valet
w User Programmable Manual Override Code
w 7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming
w Intrusion Alert with Memory
w Audible Arm / Disarm / Defective Zone / Tamper Confirmation
w Instant Siren Activation
w Starter Disable
w True Last Door Arming ( hardwire only )
w Defective Zone By-Pass
w Hardwire or Voltage Sense Selectable
w Active or Passive Arming Selectable
w Smart Disarming
w Programmable Auto Lock On / Off
w Programmable Auto Unlock On / Off
w Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
w Programmable Active or Passive Door Locks
w User Programmable Permanent Chirp Delete
w On Command RF Chirp Delete from Transmitter Or Selectable Through Software
w 6 Tone Multi-Tone Siren, (And Or),
w Car Horn Activation for additional alarm response
w Additional Negative Trigger Input
w RF Inhibit with ignition on
w Parking Light Flasher
OPTIONS :
w Remote Trunk Release ( must have electronic trunk release )
w Remote Keyless Entry ( must have power door locks )
w Illuminated Entry
w Multiple Vehicle Capable
w Headlight Illumination during Arming and or Disarming
w Remote Starter
w Remote Power Window Roll Up
w Remote Garage Door Interface
w Plug In Electronic Shock Sensor
w Interior Illumination Upon Disarm
Model PRO 9644a
Owner's Manual
128-6619
1 of 10

Advertisement

Table of Contents
loading

Summary of Contents for Audiovox Pursuit PRO 9644a

  • Page 1 Headlight Illumination during Arming and or Disarming w Remote Starter w Remote Power Window Roll Up w Remote Garage Door Interface w Plug In Electronic Shock Sensor w Interior Illumination Upon Disarm Model PRO 9644a Owner’s Manual 128-6619 1 of 10...
  • Page 2: Your " Code Hopping " Transmitters

    YOUR " CODE HOPPING " TRANSMITTERS The transmitters included with your new security system use the most advanced and secure form of radio frequency transmission available on any current automotive security system. Some of today’s sophisticated auto thieves use a device known as a code grabber, which will receive and store the signal from your keychain transmitter, and re-transmit at a later time to disarm your system.
  • Page 3: Arming The System - Passive ( Automatic )

    þ Siren will not sound. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correction.
  • Page 4: Disarming The System

    o Whenever the system is triggered, the vehicle’s horn will beep for the full 30 second alarm cycle, attracting added attention to the vehicle. o Optional - Whenever the system is triggered, the interior courtesy lights will flash for the full 30 second alarm cycle. þ...
  • Page 5: Silent Disarming

    SILENT DISARMING 1. As you approach the vehicle, press and hold the Unlock button on the keychain transmitter for 2 seconds. þ Red dash mounted LED turns off. If passive arming was selected during the installation, then the LED will start flashing rapidly, indicating that the system is re-arming automatically.
  • Page 6: Valet Switch

    Œ If the LED is flashing one time...pause...one time...pause...etc., then an intrusion attempt was made to the OPTIONAL shock sensor, or an accessory triggering device that may have been added to the system.  If the LED is flashing two times...pause...two times...pause...etc., then an intrusion attempt was made to a hood or trunk pin switch that was added to the system, or to a light activated entry point if the alarm was installed using the voltage sensing feature.
  • Page 7 1. Disarm the system by use of the transmitter, or by use of the emergency override sequence. Turn the ignition switch to the on position. 2. Within 10 seconds, press and release the valet/override switch, 3 times. 3. Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will beep and the lights will flash one time.) 4.
  • Page 8: Eliminating The Normal Arm / Disarm Chirps

    5 seconds during any of the above steps, the unit will revert back to the last successfully stored code. MANUALLY OVERRIDING YOUR SYSTEM: USING THE CUSTOM CODE OVERRIDE Assuming the override code programmed has not been changed, and the default override code of 11 is in the system's memory.
  • Page 9 allotted 30 seconds, however, the security system will be disarmed allowing the vehicle to start. OPTIONAL DEVICE OUTPUT (CHANNEL 3) Controlled By: o Option Button, o Both Lock & Unlock Button, o Both Option & Lock Button, or Both Option and Unlock Button. This security system is equipped with an output which will activate when the appropriate transmitter button is depressed for four seconds.
  • Page 10 Headlight Illumination during arm & disarm o Passive Arming o No Lock in passive mode o Hardwire doors, hood, and trunk o Custom Code Override o Valet Switch Override © 2003 Audiovox Electronics Corporation, Hauppauge, N.Y. 11788 PRO 9644 PASSIVE ARMING ARMED DISARMED VALET MODE...

This manual is also suitable for:

Pro 9644augh

Table of Contents