Audiovox Pursuit PRO-9600 Owner's Manual page 5

PROGRAMMING YOUR MANUAL OVERRIDE CODE:
Your security system can be disarmed without the use of the keychain transmitter. This is
necessary, since you will need the ability to disarm the system if you lose your transmitter, or
if the transmitter battery fails.
In order to provide the highest level of security, this system will allow you to program your
personal manual override code. This two (2) digit code comprises a first digit which must be
a digit from 1 through 9, and a second digit which must be either 1, 2, or 3.
To program your override code, the unit must be in the disarmed mode. Once disarmed,
program your code as follows:
1. Turn the ignition switch on, then off, then on.
2. Within three seconds of step 1, move the valet switch on, then off. The siren will emit one
short chirp followed by one long chirp. This indicates that the system is in the manual
override programming mode.
3. The dash mounted LED will begin to count by flashing. Allow the LED to count up to the
first digit you've selected, (1 through 9).
4. As soon as the LED flashes the corresponding count of your first selected digit, quickly turn
the ignition key;
a) Off then on one time for second digit 1
b) Off then on two times for second digit 2
c) Off then on three times for second digit 3
5. The siren will emit one short chirp, followed by one long chirp, indicating that the code has
been memorized.
6. After a 2 second pause, the LED will flash confirmation of the stored code, beginning with
the first digit, pause then the second digit.
EXAMPLE: To program the code 52, you would;
1. From the disarmed state, turn the ignition key on, then off, then on.
2. Within 3 seconds, flip the valet switch on, then off.
The siren will emit one short chirp followed by one long chirp. This indicates that the
system is in the manual override programming mode.
3. Allow the LED to flash 5 times and during or immediately after the fifth flash, quickly turn the
ignition key off, then on, then off, then on.
4. The siren will emit one short chirp followed by one long chirp, indicating that the code has
been memorized.
5. After a 2 second pause, the LED will flash 5 times, pause then flash 2 times. This confirms
that the code, 52, has been successfully programmed and stored into memory.
USING YOUR MANUAL OVERRIDE:
It is very important that you understand the operation of the manual override feature as there
may be times that you need to bypass the alarm system if your transmitter is lost or becomes
inoperative due to battery failure. You should also write down your personal custom override
code, and keep it in a safe accessible place within the vehicle for future reference.
To override the alarm system:
1. Open the door the alarm will sound.
2. Turn the ignition key to the on position. The alarm will stop sounding for three seconds,
then the siren will begin counting with long chirps. First chirp = 1, second chirp = 2, third
chirp = 3 ....
5