Intended Use; Part 2: Installation - involight COBPAR100HEX User Manual

1.3 Intended Use:

This device is an effect spotlight that can be used to create decorative lighting effects. This device is for
professional applications, e.g. B. on stages, in discos, theaters etc. and is not suitable for room lighting in
households. This product is only approved for connection to AC100-240 V, 50/60 Hz AC voltage and was
designed exclusively for indoor use. When choosing the installation location, make sure that the device is not
exposed to excessive heat, moisture and dust. Make sure there are no cables lying around. You endanger your
own and the safety of third parties! The ambient temperature must be between -5 ° C and + 45 ° C. Keep the
device away from direct sunlight and radiators. Do not start up the device until you have become familiar with its
functions. Do not allow the device to be operated by people who are not familiar with the device. Please note that
unauthorized changes to the device are prohibited for safety reasons. If the device is used in a different way than
that described in this operating manual, this can damage the product and void the warranty. In addition, any other
use with dangers such. B. short circuit, fire, electric shock, crashes etc. connected.

Part 2: Installation:

Unpack the device and check it carefully for damage before using it. Place the device in a suitable place or hang it
on a suitable crossbar. If the device is suspended, the device must be secured with an approved safety rope. In
addition, the mounting bracket must be screwed on and tightened using the enclosed screws! Then connect the
device to the mains and, if required, connect a DMX cable and connect it to other devices or a DMX controller.
More about DMX or master / slave operation also in part 3.
During installation, the provisions of BGV C1 (formerly VBG 70) and DIN 15560 must be observed in
particular! The installation may only be carried out by authorized specialists!
IMPORTANT! Overhead assembly requires a high level of experience. This includes knowledge of the calculation
of the load capacity, of the installation material used and safety inspections of the material used and the projector,
although the experience required is not limited to this. Under no circumstances try to do the installation yourself if
you do not have the necessary qualifications. Instead, hire a professional installer. Improper installation can result
in injury and / or property damage.
NOTE!
Use of tripods.
If the device is mounted on a tripod, make sure that it stands firmly and that the weight of the device does not
exceed the permissible load capacity of the tripod.
NOTE!
Please note that this device cannot be connected to a dimmer.
18