involight COBPAR100HEX User Manual page 21

RUN SELECTION MODE
DMX START ADDRESS
DMX
SELECTION OF DMX
PERS
MODE
ID ID ADDRESSING
TEMPERATURE
TEMP
DISPLAY
CHANGE
EDIT
PROGRAMS
SET
SETTING
DMX
SLAV
D.001 - D.512
STRG
ARC.1
AR1.D
ARC.2
AR2.D
AR2.5
HSV
to operate up to 66 devices on a single DMX
ID01 - ID66
CURR
PR.01 - PR.10
SC.01 - SC.30
R (000-255)
G (000-255)
B (000-255)
Y (000-255)
W (000-255)
U (000-255)
ST. (00-20)
T. (000-255
F. (000-255)
UPLD
Password: [UP] + [DOWN] + [UP] + [DOWN]
REST
ID (OFF/ON)
RGBW (OFF/ON)
20
Operation in DMX mode.
Operation in slave mode.
Set DMX start address.
13-channel operation (TAB.6)
3-channel operation (TAB.1)
4-channel operation (TAB.2)
6-channel operation (TAB.3)
7-channel operation (TAB.4)
8-channel operation (TAB.5)
3-channel operation (TAB.8)
Selection of the ID address. The ID is used
address. The ID is selected directly on the
device in the settings. The device with the
set ID is then controlled at the control panel
via the value of channel 13.
The inside temperature is displayed in ° C.
In this menu you can change the programs
[PR.01] to [PR.10].
Each program has 30 steps, which can be
changed. Each of these steps enables the
creation of a scene with the following
parameters: red, green, blue, amber, white,
UV, strobe, time, fade. Hold down the
ENTER key for approx. 5 seconds to save
the data.
RED, Intensity R000 – R255
GREEN, Intensity G000 – G255
BLUE, Intensity B000 – B255
AMBER, Intensity A000 – A255
WHITE, Intensity W000 – W255
UV- / BLACK LIGHT,
Intensity UV000 – UV255
Flash frequency of the stroboscope
Scene duration (time) in seconds
Fade time
With this function you can transfer all
programs from the MASTER device to the
SLAVE devices.
and confirm with ENTER.
Reset the program.
You can activate or deactivate the second
addressing (ID) in the [ID] menu.
Enable or disable internal white balance.