Sega Giant Plants vs Zombies The Last Stand Manual page 50

The wire connected to the volume pot will be reused. Use a tool such as a pair of snips or cutters to remove
6
the old heatshrink tubes which cover the contacts.
Use a soldering iron to melt the solder and seperated the wires from the old volume pot. Be very careful
7
when using a soldering iron.
7
If the exposed conductive wire at the end is less than 5mm, use a tool such as a wire stripper or cutter to cut
8
the wire insulation back to a workable length. Place new sleeving over the wire before resoldering them to
the pot.
Once soldered, cover the bare contacts with the sleeving. If heatshrink is used, apply heat from an
9
appropriate hot air blower to shrink the sleeving tightly over the contacts.
Reassemble the pot to the pot bracket by working in reverse order of these instructions.
1 0
Refer to the POT VOLUME ADJUSTMENT section of this manual.
41