Mounting Of Motor And Coupling Adapter - Bosch Hagglunds CB Installation And Maintenance Manual

7.4.4

Mounting of motor and coupling adapter

Slipping shaft.
Damage of motor or customer shaft.
▶ Grease must under no circumstances be transferred to the surfaces between the
driven shaft and the coupling motor or shaft adapter (see Fig. 34).
▶ Clean hands free from grease before start of mounting
Mounting of shrink disc to adapter shaft or coupling motor
1. The shrink disc arrives from the factory lubricated with grease on the conical
surfaces and the screws (see Fig. 34). This lubricants shall remain on these
surfaces.
2. Clean the outside of the hollow shaft.
3. Remove the spacers between the two clamping rings of the shrink disc.
4. Mount the shrink disc on the hollow shaft. Use an approved sling between the
clamping rings.(see Fig. 33 and Fig. 34) The coupling must be pushed completely
to the stop of the hollow shaft. If nescesary separate the clamping ring for easier
mounting.
5. Absolutely no grease on the surfaces between driven shaft and hollow shaft.
Clean the driven shaft and the inside of the hollow shaft
RE 15302-WA/05.2019, Hägglunds CB, Installation and maintenance manual , Bosch Rexroth Mellansel AB
NOTICE
Installation 37/68