Bosch Hagglunds CB Installation And Maintenance Manual page 36

36/68 Installation
Bosch Rexroth Mellansel AB, Installation and maintenance manual , Hägglunds CB, RE 15302-WA/05.2019
Hydraulic connection between motor and hydraulic cylinder
This is valid with the hydraulic cylinder on the right hand-side of the the motor.
See Fig. 32
1. Mount the hoses, The hose mounted to connection T4A has to be mounted to the
hydraulic cylinder connection (A) and the hose from connection T4C has to be
mounted to the cylinder connection (B).
Fig. 32: Hydraulic connections DTCB
Table 13: Hydraulic connections DTCB
Connection Description
T4A Pressure connection
T4C Pressure connection
A Pressure connection
B Pressure connection
C Air ventilation
Overload of driven shaft!
Damage of equipment.
▶ Make sure to follow the installation instructions regarding hydraulic connections
The cylinders should be vented from air during commisioning by using the air
bleeding screws on the cylinder, see Fig. 31
Air bleeding
A port
T4A T4C
Air bleeding
B port
Dimensions Remarks
To be connected to A on
G½˝
cylinder
To be connected to B on
G½˝
cylinder
G½˝
G½˝
G½˝ Air filter
NOTICE
DD00100397
A
B
C