Bosch Hagglunds CB Installation And Maintenance Manual page 39

Mounting the coupling adapter to the driven shaft
1. Mount 3 lifting eyes on the coupling adapter for lifting, see Fig. 9 in chapter
2. Align the coupling adapter with the driven shaft.
3. Pass the assembly tool through the centre of the coupling adapter and screw it
into the driven shaft by using the squared key in the end of the tool, see Fig. 35
4. Pull the coupling adapter on the shaft by turning the nut on the assembly tool to
specified clamping length (length B, see Fig. 36 and Fig. 37 and Table 14).
5. Tighten the shrink disc, (see : Tightening of shrink disc page 41).
6. Remove the assembly tool.
7. Remove the lifting device and the lifting eyes from the coupling adapter.
Driven shaft
Fig. 35: Mounting the coupling adapter on the driven shaft with the assembly tool.
Assembly tool
1 Nut
2 Carriage beam
RE 15302-WA/05.2019, Hägglunds CB, Installation and maintenance manual , Bosch Rexroth Mellansel AB
Coupling adapter
1
Installation
DD00058276, DD00080049
2
39/68
6.1.2.