Safety Instructions; About This Chapter; Intended Use; Improper Use - Bosch Hagglunds CB Installation And Maintenance Manual

2 Safety instructions

2.1 About this chapter

This product was made in accordance with the generally accepted rules of the
industry but there is a risk of personal injury and damage to property unless you
follow this chapter and the safety instructions in this documentation.
▶ Read this documentation carefully, in full, before using product.
▶ Keep this documentation so it is accessible to all users at all times.
▶ Always give products to third parties with the required documentation.

2.2 Intended use

The Hägglunds CB is a radial piston hydraulic motor.
In an application the CB motor is classified as component in the sense of the EU
machine directive 2006/42/EC. Partly completed machinery is exclusively intended
to form an incomplete or a complete machine together with other components or
partly completed machinery. The CB motor may only be commissioned after it has
been installed in the machine/system for which it is intended and the safety of the
entire system has been established in accordance with the machine directive.
Intended use includes having read and understood the complete documentation,
especially the Chapter 2: Safety instructions.
The product is intended for the following use:
• Radial piston motor in open or closed circuit: The radial piston motor is only
approved to be used in motor mode or pump mode.
Observe the technical data, application and operating conditions and performance
limits as specified in the product-specific data sheet and in the order confirmation.

2.3 Improper use

Any use other than that described as intended use shall be considered as improper
and is therefore impermissible.
Bosch Rexroth shall accept no liability whatsoever for damage resulting from
improper use. The user shall bear all risks arising from improper use.
Similarly, the following foreseeable faulty usages are also considered to be improper:
• Using outside the operating parameters approved in the product-specific data sheet
or in the order confirmation (unless customer-specific approval has been granted)
• Use of fluids outside of the standards as specified in 15.1.1: Hydraulic fluids and in
Data sheet RE 15414
• Modification of factory settings by non-authorized persons.
• Use of add-on parts (e.g. mountable filter, control unit, valves) that are not
specified by Bosch Rexroth must be approved by contact at Bosch Rexroth.
• Extension or conversion is not permissible and has to be approved by contact at
Bosch Rexroth.
RE 15302-WA/05.2019, Hägglunds CB, Installation and maintenance manual , Bosch Rexroth Mellansel AB
Hydraulic fluid quick reference.
Safety instructions 7/68