MasterCraft 055-6739-8 Owner's Manual page 33

Saw does not make
accurate 90º or 45º
cuts
Height/bevel-
adjusting hand
wheel is hard to
turn.
Saw does not start
Blade makes poor
cuts
Blade does not
lower when turning
the Height/bevel-
adjusting hand
wheel
Positive stops inside the
cabinet need adjusting
(Bevel cuts)
Mitre gauge is misaligned
(Mitre Cuts)
Gear and screw post
inside the cabinet are
clogged with sawdust.
Motor cord or wall cord is
not plugged in.
Circuit fuse is blown
Circuit breaker is tripped
Circuit switch is damaged
Blade is dull or dirty
Blade is the wrong type
for cut being made
Blade is mounted
backwards
Locking lever is not at full
left position
33
Adjust the positive stops
Adjust the mitre gauge
Clean the gear and screw
post.
Plug in motor cord or
wall cord
Replace the circuit
breaker
Reset the circuit breaker
Have the cord or switch
replaced by a qualified
service technician.
Clean, sharpen or replace
the blade
Replace with the proper
type
Remount the blade
Move the locking lever to
the left