Ip Settings In The "Search For Devices" Window ("Communication" View) - Eaton easyE4 Application Note

Establish ethernet connection between easye4 and easysoft v7

Hide thumbs Also See for easyE4:

Table of Contents

NOTE: The option "Enable configuration via network" is enabled in the device as factory setting. This

enables you to make changes to the IP settings of the device via network in the "Search for devices"

window ("Communication" view) after initial communication with the easyE4. If the check mark for

"Enable configuration via network" is not set in the *.e70 project or in the "Search for devices" win-

dow and the *.e70 project or the IP settings are transferred, changes to the IP settings in the device

are no longer possible via "Search for devices". The configuration can then only be changed by reset-

ting to factory settings or project transfer.

3.2 IP Settings in the "Search for devices" Window ("Communication" View)

The easyE4 must be connected to the PC.

1. Go to the "Communication" view

2. Click on "Search..." under IP Devices. A new window "Search for devices" opens.

Application Note Establish Ethernet connection between easyE4 and easySoft V7 04/2020 AP050013ENEN www.eaton.com

Table of Contents