Eaton easyE4 Application Note page 17

Establish ethernet connection between easye4 and easysoft v7

Hide thumbs Also See for easyE4:

Table of Contents

NOTE: The option "Enable configuration via network" is enabled in the device as factory set-

ting. This enables you to make changes to the IP settings of the device via network in the

"Search for devices" window ("Communication" view) after initial communication with the

easyE4. If the check mark for "Enable configuration via network" is not set in the *.e70 pro-

ject or in the "Search for devices" window and the project or the IP settings are transferred,

changes to the IP settings in the device are no longer possible via "Search for devices". The

configuration can then only be changed by resetting to factory settings or project transfer.

5. Switch from the "Project" view to the "Communication" view.

6. Click on "Search..." under IP Devices. The "Search for devices" window opens.

Application Note Establish Ethernet connection between easyE4 and easySoft V7 04/2020 AP050013ENEN www.eaton.com

Table of Contents