Auto-Iris Adjustment - Sony Power HAD FX HSC300R Service Manual

2. Make a line selection at the center white portion of the grayscale chart.
3. Operate the menu of MSU-1000.
1) PAINT button → ON (lit)
2) Touch panel operation: (Page 1) → [Detail] → [3/3]
4. Adjust the W Limiter so that the edge at portion B to the desired clip level.
5. Operate the menu of MSU-1000.
1) PAINT button → ON (lit)
2) Touch panel operation: (Page 1) → [Detail] → [3/3]
6. Adjust the B Limiter so that the edge at portion C to the desired clip level.
3-4-6.

Auto-iris Adjustment

Equipment: Waveform monitor (R, G, B)
Test Point: SDI connector
Object: Grayscale chart
Preparation
• Setting for MSU-1000
AUTO IRIS button → ON (lit)
KNEE OFF button → OFF (lit)
• Shoot the grayscale chart so that the chart frame is aligned with the under scanned monitor frame.
HSC300RF/HSC100RF/HSC300R/HSC100R
Line selection
B
C
3-20