Se-1138 Board (Hsc100R/100Rf) - Sony Power HAD FX HSC300R Service Manual

2-4-7.

SE-1138 Board (HSC100R/100RF)

Preparation
1. Open the outside panel assembly.
• HSC300R/100R: Refer
• HSC300RF/100RF: Refer
2. Remove the CCD unit. (Refer
Procedure
1. Disconnect the harness from the connector (CN1) on the SE-1138 board.
2. Remove the three screws to detach the filter ID plate and the SE-1138 board.
Harness
Knob shaft
Filter with the lightest color
(1: clear)
Note
When installing the SE-1138 board, turn the knob shaft to a position where the filter with the lightest color (1: clear)
appears when viewed from the lens mount section.
3. Install the removed parts by reversing the steps of removal.
4. Perform "Actions to Be Taken during Board Replacement and after Board Replacement/Repair". (Refer to
Notes on Replacement of Parts and Circuit
HSC300RF/HSC100RF/HSC300R/HSC100R
to"2-2-1. Outside Panel Assembly (TRIAX)"
to"2-3-1. Outside Panel Assembly (Fiber)"
to"2-4-2. CCD Unit (HSC100R/100RF)")
CN1
SE-1138 board
Board")
PSW2 x 5
PSW2 x 5
Filter ID plate
"1-4.
2-18