Intercom Panel - Sony Power HAD FX HSC300R Service Manual

2-13.

Intercom Panel

Preparation
1. Remove the inside panel assembly. (Refer
Procedure
1. Disconnect the flexible flat cable from the connector (CN5) on the SY-430 board.
2. Disconnect the two harnesses from the two connectors (CN7, CN103) on the SY-430 board.
3. Open the connector (1) cap.
4. Remove the six screws and draw the intercom panel.
CN5
CN7
CN103
SY-430 board
Note
• When installing the intercom panel assembly, arrange the harness as shown in the figure.
Flexible flat cable
Harness
5. Install the removed parts by reversing the steps of removal.
HSC300RF/HSC100RF/HSC300R/HSC100R
to"2-1. Inside Panel")
Harness
Flexible flat cable
Harness
Connector (1) cap
DC OUT bracket
Intercom panel
B2 x 5
B2 x 5
2-32