Maintenance - Bosch Rexroth IndraControl VPB 40.4 Operating Instructions Manual

IndraControl VPB 40.4
Errors
No image output
No or incorrect network data transmission if the
data transmission rate is set manually
Tab. 13-1: Error causes and troubleshooting
Repairs at the device by the customer are not permitted. Exceptions
are maintenance works listed in the chapter "Maintenance".
For further information in the event of repair, please contact the
Bosch Rexroth Service.

14 Maintenance

Only the maintenance works at the device listed in this chapter are
permitted.
For further information in the event of repair, please contact the
Bosch Rexroth Service.
NOTICE
Do not use any solvents (e. g. diluents) for cleaning!
●
NOTICE
Use only copper wire for wiring the connection terminals. Tighten the screws of
the screw terminals with the following torque:
Troubleshooting
For CDI interfaces:
Check that both CDI cables (XSER and XVID)
●
are connected
Check that the CDI cables (XSER and XVID) are
●
not interchanged
For CDI+ interfaces:
Check whether the CDI+ cable is connected
●
The network card of the remote station has to be
able to process the same data transmission rate as
the control cabinet PC. If necessary, change the
data transmission rate under Control
Panel ▶ Network Card
Dissolving the labeling
solvents!
Destruction of screw terminals, insufficient
contact and loss of UL certification if no copper
wire is used or due to wrong tightening torque.
R911376309_Edition 02 Bosch Rexroth AG
45/57
Maintenance
at the device by