Connecting Usb Device, Msata Module And Mpcie Module At The Internal Connection - Bosch Rexroth IndraControl VPB 40.4 Operating Instructions Manual

IndraControl VPB 40.4
Possible restrictions for the 2-slot variant:
When using a PCI card or a PCIe card with a card length > 145 mm,
the USB port is covered by the card. The USB port can then only be
used for very short USB sticks (e.g. mouse radio receiver).
Mounting an mSATA SSD hard disk module at the 2-slot variant:
The mSATA SSD hard disk module has to be installed before
installing a PCI card or a PCI card with a card length > 145 mm, as
the mSATA base of the plug-in card is covered after mounting such
cards.
10.1.4 Connecting USB device, mSATA module and mPCIe module at
the internal connection
It is recommended to install the modules to be mounted before
mounting the control cabinet PC into the control cabinet.
NOTICE
Comply with all ESD protective measures while working with modules and
components! Avoid electrostatic discharges!
NOTICE
Install only released modules and USB devices
●
Modules and USB devices may only be installed by authorized personnel
●
Steps 1 - 4 are omitted if the control cabinet PC is not yet mounted into the con-
trol cabinet.
1. Switch off the supply voltage.
2. If operated with a UPS, wait until the control cabinet PC switches off
automatically. The UPS LED on the connector panel of the control cabinet
PC is red until the UPS switches off the power supply unit.
3. Remove all plugs from the control cabinet PC.
4. Loosen the fastening screws of the control cabinet PC and remove the
control cabinet PC from the mounting panel.
5. Position the control cabinet on a plane support and ensure that the right
housing cover points up.
Mounting, demounting and electric installation
Damages to the device due to electrostatic
discharges!
Risk of damage to the IndraControl VPB 40.4 by
mounting non-released
devices!
R911376309_Edition 02 Bosch Rexroth AG
23/57
modules and USB