Table of Contents
Advertisement
If the aircraft status indicator blinks red and yellow alternatively after calibration is completed, this
indicates that the current location is not suitable for flying the aircraft due to the level of magnetic
interference. Choose a new location.
A prompt will appear in DJI Fly if compass calibration is required before takeoff.
The aircraft can take off immediately once calibration is complete. If you wait more than three
minutes to take off after calibration, you may need to calibrate again.
Updating Firmware
When you connect the aircraft or remote controller to DJI Fly, you will be notified if a new firmware
update is available. To update, connect the mobile device to the internet and follow the on-screen
instructions. Note that the firmware cannot be updated if the remote controller is not linked to the
aircraft.
Make sure to follow all the steps to update firmware. Otherwise, the update may fail. The aircraft will
power off automatically after the firmware update is complete.
The firmware update will take approx. 10 minutes. It is normal for the gimbal to go limp, aircraft
status indicators to blink, and the aircraft to reboot. Wait patiently until the update is complete.
Before performing an update, make sure the Intelligent Flight Battery is at least 15% charged and the
remote controller is at least 20% charged.
The remote controller may become unlinked from the aircraft after updating. Relink the remote
controller and aircraft. Note that the update may reset various main controller settings, such as the
RTH altitude and the maximum flight distance, to default settings. Before updating, take note of your
preferred DJI Fly settings and readjust them after the update.
After-Sales Information
Visit https://www.dji.com/support to learn more about after-sales service policies, repair services, and
support.
DJI Mini 2 User Manual
©
2021 DJI All Rights Reserved.
49
Hide quick links:
Advertisement
Table of Contents
