Upgrading The Firmware - dji MG-1S User Manual

Rapidly Blinking Yellow
Slowly Blinking Red
Rapidly Blinking Red
Solid Green

Upgrading the Firmware

Aircraft Firmware
Connect the Micro USB port of the aircraft to DJI Assistant 2 on your computer to update the
aircraft firmware. Refer to the DJI Assistant 2 (p. 48) section for details.
Remote Controller Firmware
Power on the remote controller and update the remote controller firmware in the DJI MG app.
1. Enter Operation View > System Status bar > Aircraft Status List to check the current firmware
version. Follow the instructions in the DJI MG app to finish the update if there is a new version.
2. The Status LED will turn solid green when the update is successful. The LED will turn solid red if
the update fails. Restart the remote controller and try again.
The firmware update process takes approximately 10 minutes. We recommend finding a
comfortable environment to carry out the update.
Both the remote controller and aircraft firmware must be up-to-date, or else they will not
link.
Check the DJI MG app that you have the latest firmware installed before every flight.
The firmware update requires an internet connection. Connect the display device to a Wi-
Fi network whenever possible.
Wait for the progress bar to reach 100% to ensure that the firmware update is complete.
The remote controller status indicator glows solid blue during the update.
DO NOT power off the remote controller during the update.
DO NOT perform the firmware update while the aircraft is in the air. Only carry out the
firmware update when the aircraft is on the ground.
The remote controller may become unlinked from the aircraft after the firmware update.
Relink the remote controller and aircraft if necessary.
Remote controller signal lost
Low battery level
Critical low battery level
System Data Protection function working
AGRAS MG-1S User Manual
© 2017 DJI All Rights Reserved.
53