Vision System And Infrared Sensing System - dji MINI 2 User Manual

DJI Mini 2 User Manual
If the aircraft is at an altitude of 65 ft (20 m) or higher and has not yet reached the RTH altitude, the
throttle stick can be moved to stop the aircraft from ascending and the aircraft will fly to the Home
Point at its current altitude (only available with firmware v1.0.0.0. This function is not available when
the firmware is updated to v1.1.0.0 or later).
During RTH, the speed, altitude, and orientation of the aircraft can be controlled using the remote
controller if the remote controller signal is normal. However, the remote controller cannot be used to
pan left or right. When the aircraft is ascending or flying forward, the user can push the control stick
completely in the opposite direction to make the aircraft hover in place.
GEO zones will affect RTH. If the aircraft flies into a GEO zone during RTH, it will either descend until it
exits the GEO zone and continue to fly to the Home Point or hover in place due to altitude limits.
The aircraft may not be able to return to a Home Point when the wind speed is too high. Fly with
caution.
Landing Protection
Landing Protection will activate during Smart RTH.
1. During Landing Protection, the aircraft will automatically detect and carefully land on suitable ground.
2. If the ground is determined unsuitable for landing, DJI Mini 2 will hover and wait for pilot confirmation.
3. If Landing Protection is not operational, DJI Fly will display a landing prompt when the aircraft
descends below 0.5 m. Tap confirm or pull down on the throttle stick to land.

Vision System and Infrared Sensing System

DJI Mini 2 is equipped with a Downward Vision System and Infrared Sensing System. The Downward
Vision System consists of one camera and the Infrared Sensing System consists of two 3D infrared
modules. The Downward Vision System and Infrared Sensing System helps the aircraft maintain its
current position, hover in place more precisely, and to fly indoors or in other environments where GPS is
unavailable.
Detection Fields
The Downward Vision System works best when the aircraft is at an altitude of 0.5 to 10 m and its
operating range is 0.5 to 30 m.
©
16 2021 DJI All Rights Reserved.
Infrared Sensing System
Downward Vision System
56°
71°