Dual Ethernet; Genius Configuration Parameters - Datalogic SC6000 Installation Manual

3.7 DUAL ETHERNET

Each controller (Dual Ethernet models) is able to interface to the host computer through two
different Ethernet networks. The dual Ethernet is intended to allow the physical replication of the
connection to the host computer, however dual Ethernet is not managed by REDS.

3.8 GENIUS CONFIGURATION PARAMETERS

Parameter
Redundancy Parameters
Reds Functionality
Sentinel Operating Mode
Topology Redundancy Role Master Alone/Master Working
IP Address Selection Rule
Redundancy Parameters
\Redundancy
Parameters
Check Presence
Failure
Presence Sensor
Event Filter
Check Encoder Failure
Values (default)
Enable/Disable
Standard/Redundant
/Master Protecting
Redundancy
/Topology Role (W/P)
Switch
Sensor Enabled/Disabled
Failure 1-10; (2)
Enabled/Disabled
Function
Redundancy Role Parameters
Enables/disables REDS
(only available to "Supervisor" –
read-only for "User")
Sentinel Agent operating mode.
Standard:
redundant, no diagnostic digital
input
Standby system is reported
Redundant: diagnostic digital input
information
system is reported. The digital
input diagnostic information of the
active controller is replaced with
the
controllers (4 inputs Active + 4
inputs Standby)
Topology
connected
address
Working,
selection of Topology Role to
Working/Protecting
default value Active/Standby for
the Redundancy Role (read-only)
Role (A/S) Defines the IP address selection
policy for the interface to both
Sentinel and the Host:
Topology Role: fixed IP address
Redundancy
depending on the dynamic role
Active/Standby
configuration parameters
Presence
affects the switch over
Number of times the alarm must be
repeated before the switch over
occurs
Encoder diagnostics affects the
if the system
information about
about the Standby
diagnostics of both
Role. Explicitly
to the Lonworks
of the controller
63 Protecting).
implies
Role: variable
switch
sensor diagnostics
is
the
the
(0:
The
the
IP
over