Table of Contents
Advertisement
Note:
If multiple filter fields are configured, only those packets matching
▶
all filters will be allowed to pass through.
In the
Advanced
tab allows the configuration of some other options that can be
applied on the traffic in outbound:
ACTION TYPE
DROP/ACCEPT
GTP IPv4/ IPv6
Filtering
Strip VLAN
Tag/ Add
VLAN Tag
Slicing
ERSPAN Tunneling
MPLS Strip
VXLAN/ERSPAN
Strip
ERSPAN Tunnel
DESCRIPTION
the packet matching the specified filter can be dropped
or accepted. Dropping is meant to be used when it is
necessary to discard a subset of the traffic which is
forwarded by a broader filter.
this action allows the user to filter the IPv4/ IPv6 source/
destination addresses inside a GTP tunnel.
A VLAN header with the specified VLAN ID can be added. The
new tag is always added externally. Packet EtherType fields
are guaranteed to be updated automatically. If VLAN Strip is
present, the outer VLAN TAG is removed. If both options are
enabled at the same time, the board will replace the external
VLAN ID tag with the one specified.
Truncates the packet to the specified size between 64 and
9215 bytes.
De-Tunnel: strips ERSPAN encapsulation
Tunnel: encapsulates packets using the specified ERSPAN
tunneling settings
Remove the outer MPLS label in all packets passing through
the rule.
Strip all the headers of a VXLAN or ERSPAN tunnel.
Encapsulate the traffic passing through the rule in a ERSPAN
Tunnel. The address fields to be used in the tunnel must be
specified
15
Advertisement
Table of Contents
