JOBO JOBOBIKE Bruno Owner's Manual page 16

Step 6
Inflate the tyres.
Check that the tyre beads and tyres are evenly seated on the rims. Use a pump with a Schrader valve and
pressure gauge to inflate each tyre to the recommended pressure value indicated on the tyre sidewall,
35-60 psi (2.5 – 4.1 bar).
.
Do not overinflate or underinflate tyres
Step 7
Set the desired seat height.
Open the quick release lever by hinging it open fully. Ensure that the seat post clamp opening is aligned
with the notch at the front of the seat tube. Adjust the seat post up or down to a comfortable height, while
ensuring that the seat post is inserted into the frame past the minimum insertion point. If needed, use the
thumb nut to add tension to the clamp so there is enough resistance when the lever is in line with the
clamp bolt, but do not overtighten. Close the quick release lever to secure the seat post and make sure
that it does not move. See the Adjusting the Seat section of this manual for more details.
Step 8
Always check that the battery is locked to the frame of the E-bike before riding
Operate the electrical system when the battery has been adequately charged and the battery is secured to
the mounting receptacle on the frame.
15