JOBO JOBOBIKE Bruno Owner's Manual page 14

4.3
When properly installed, the front wheel should be at the center of the front fork, the brake rotor
should be between the brake pads in the brake caliper, and the quick release lever should be fully se-
cured. Make sure that the front wheel and quickr elease lever are properly secured before moving on
to the next step
NOTICE: For safety reasons, the quick release lever MUST be locked tightly
enough.Never touch the brake rotor, especially when the wheel and/or bike is in
motion, or serious injury could occur. Hand oils can cause squeaking and de-
crease brake performance; do not touch the brake rotor while inspecting, open-
ing, or closing the quick release lever.
tep 4
S
41. Remove the headlight mounting bolt from the fork arch.
4.2. Fix the headlight on the front fork arch with bolts. Ensure that the headlight is centered and set all mounting bolts to the recom -
mended torque value (6 Nm)
4.3. Plug in the headlight.
Locate the two sides of the red, two-pin headlight connector, carefully align the internalpins and notches and external arrows, then press
directly together without twisting to fullyseat the connection.
he fender clamps on both sides are parallel
4.4. Adjust the headlight angle to illuminate the road ahead but not to blind oncoming traffic. Use a 3 mm hex wrench and 8 mm wrench to
loosen the headlight angle adjustment bolt, tilt the headlight to the optimal position, and then tighten in place securely.
13