JOBO JOBOBIKE Bruno Owner's Manual page 11

Place the handlebar on the stem correctly.
Trace the front brake cable directly up from the
front brake caliper to the left handlebar and
ensure that the cables and wires are not
twisted.
Centre the handlebar and tighten the four stem
faceplate bolts evenly.
Adjust the stem angle using the Allen bolts on
the side of the stem if desired. Adjust the han-
dlebar so the grips are approximately parallel
to the rear rack.
Secure to the recommended torque value. Once adjusted properly,
use a torque wrench with a 4 mm Allen bit to evenly tighten the four stem faceplate
bolts to the recommended torque value, 6 Nm.
Get help from a bike-fitting professional.
Consult a certified bike-fitting specialist for assistance to fit the bike properly for safety,
optimal fit, and bike ergonomics.
S tep 3
3.1. Put the e-bike in safe, stable position. You can use the hard foam from the carton
box and put it under bike's fork.
3.2. Prepare the wheels – if there are any wheelhub protection, please remove.
3.3. Rotate counterclockwise and remove the thruaxle
10