Lincar Annarita 698 TP Using Instructions And Maintenance page 65

MENU 07 (load initial)
Within this Menu you can set the continuos fuel load, this operation can only be effected
when the appliance on the display is evidencing "OFF". This menu is utilized to fill the screw
feeder when the appliance is new or in case of emptying of the pellet container.
MENU 08 (status stove)
Within this Menu you can find some informations about the working of the appliance.
MENU 09 (pellet correct)
Sometimes, changing type of pellet, there are so many types of wood pellet on the market, the
combustion of the appliance can be affected. A clear signal of an unefficient combustion is
given by the quantity of pellets into the burner basket during the normal working phase: too
much or too scarce. It is possible to make some small regulations on the combustion of the
appliance. Under the assumption that during the working phase the burner basket should be
full of pellet from ¼ to half of its capacity, whenever necessary, you can make some
adjustments following the below procedures:
a- Observe the appliance and verify if the pellet is piling up till to the complete filling
of the basket or if the basket is emptying itself almost till to the extinction of the
fire.
b- Push on button 7 to enter into the Menu.
c- Run on the Menu utilizing the buttons 4 e 5 until you arrive to MENU 09
d- Push again on button 7 to accede to MENU 09.
e- An Access Key is requested, utilizing the button 2 run on the number in the upper
part of the screen until you arrive to number 33.
f- Push again on button 7 to confirm the Access Key and to enter into the modality of
combustion modification.
g- Use buttons 1 and 2 to modify the number shown on the display on the upper part,
as indicated in the below tabel; to increase the quantity of pellet you must increase
the value, to decrease the quantity of pellet, decrease the value. ATTENTION! We
recomand to modify the value increasing/decreasing by only one number per time.
Verify the working of the appliance for one or two days, after having cleaned the
burner basket, only after this period of verification eventualy make a new
regulation.
h- Terminate the regulation of the combustion pressing shortly on button 3.
increase pellets
9 8 7 6 5
MENU 10 (settings technic) RESERVED TO TECHNICIANS.
DETAILS OF MENU
Menu 00 FAN REGULATION - (System functions Fan 1 ).
Control panell Display
VENT - 1
VENT - 2
The Ventilation1 will function automatically and the Ventilation2 (if the equipment is
supplied with this function) ) will remain at speed 1
ATTENTION to the setting of the Time and the Date as they will affect the programmations
of the automatic switch ON/OFF
4 3 2 1
Description
Ventilation1
Ventilation2
65/120
IT IT IT IT- - - - GB GB- - - - FR
GB GB
decrease pellets
0 -1 -2 -3 -4
FR mod. Serie 698TP....
FR FR
-5 -6 -7 -8
Example
A
1
-9