LNS QUICK LOAD SERVO S3 T BARFEED Service Manual page 73

SETTINGS
POSITION
End of bar position (may be not visible)
The end of bar position determines the moment when the bar feeder enters the loading cycle.
In principle, the end of bar position is adjusted as closely as possible behind the lathe's clamping unit (approximately 5 mm) to
ensure the shortest remnants.
Regardless of the length of the bars or parts, the end of bar position is always the same. In very special cases, a different end
of bar setting needs to be selected.
Top-cut position(may not be visible)
During feeding, the bar is inserted in the spindle and automatically positioned in the clamping unit of the lathe.
This positioning corresponds to a value (Z) programmed by the operator, which is equal to the distance between the measuring
cell and the position of the material in the lathe clamping device.
With this system, the setting is the same for any bar length.
SERVICE MANUAL – QL Servo S3-T