Table of Contents
Advertisement
2. Load Filament
Filament Specification: Diameter :1.75mm ;Matrial :PLA; Printing temperature :200-230℃
The method of manually loading filament is carried out according to the steps:
1. Confirm that the extruder is preheated to 200 degrees;
2. A roll of PLA filament;
3. Straighten up the filament ( or cut the filament into bevels with plier );
4.
Press the screw head of the extruder and hold the extruder base, and pass the filament through the
extruder.
5. Quickly load the straightened filament into the extruder;
6. Pass through the Teflon tube until there is filament flowing out from the nozzle;
7. Filament installed successfully
Press the screw head
Insert filament vertically
here
page26of36
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the A8 Plus and is the answer not in the manual?