Chapter 9. Troubleshooting - Kernau KDI 6542 User Manual

TROUBLE
CODE
F5
F3
F2
F8
F1
FE
F7
F6
If the programme does not start:
• Check, if the plug is connected to the power socket.
• Check, the fuse.
• Check, if the water inlet is open.
• Check, if the device's door is open.
• Check, if the device is turned of with the On/OFF button.
• Check, if the filter on the water inlet or device filter are not blocked.
If in the detergent chamber remain the detergent residue:
Check, if the detergent was placed into wet detergent chamber.
If after ending the selected program, water is accumulated in the device:
• Check, if the exhaust water hose is clogged or bended.
• Check, if the filters are blocked.
• Check, if the program is not finished.
If the device interrupting the operation during washing cycle:
• Check, if power breakdown.
• Check, if water supply malfunction.
• Check, if the programe can be in standby mode.

CHAPTER 9. TROUBLESHOOTING

POSSIBLE FAULT
Insufficient water
Continuous water input
Inability to discharge water
Heater error
Overflow
Faulty electronic card
Overheating error
Faulty heater sensor
WHAT TO DO
Make sure the water inlet tap is open and water
is flowing. Separate the inlet hose from the
tap and clean the filter of the hose. Contact for
service if the error continues.
Close the tap and contact for service.
Water discharge hose and filters may be clogged.
Cancel the program. If the error continues,
contact for service.
Contact for service.
Unplug the machine and close the tap. Contact
for service.
Contact for service.
Contact for service.
Contact for service.
EN
51