Chapter 9. Troubleshooting - Kernau KDI 6443 I User Manual

WARNING
Warning Risk of cuts! When cleaning the waste water pump, ensure that you do not injure
yourself on pieces of broken glass or pointed implements.
In this case:
1. First always disconnect the appliance from the power supply.
2. Take out baskets.
3. Remove the filters.
4. Scoop out water, use a sponge if required.
5. Check the area and remove any foreign objects.
6. Install filters.
7. Re-insert baskets.
FAULT
The programme does
not start
Water remains inside
the machine
Machine stops during
washing
Shaking and hitting
noises are heard during
a wash operation

CHAPTER 9. TROUBLESHOOTING

POSSIBLE CAUSE
Your Dishwasher is not
plugged in
Your Dishwasher is not
switched on
Fuse blown
Water inlet tap is closed
Your Dishwasher door is open
Water inlet hose and machine
filters are clogged
Water drain hose is clogged or
twisted
The filters are clogged
The programme is not finished
yet
Power failure
Water inlet failure
The spray arm is hitting the
dishes in the lower basket
Switch your Dishwasher on by
Check the water inlet hose and
machine filters and make sure
Wait until the programme is
Move or remove items blocking
57
TROUBLESHOOTING
Plug your Dishwasher in
pressing the On/Off button
Check your indoor fuses
Turn on the water inlet tap
Close the Dishwasher door
they are not clogged
Check the drain hose, then
either clean or untwist it
Clean the filters
finished
Check mains power
Check water tap
the spray arm