Chapter 9. Troubleshooting - Kernau KDI 4855 SD User Manual

CHAPTER 9. TROUBLESHOOTING

TROUBLE
POSSIBLE FAULT
CODE
FF
F5
F3
F2
F8
F1
FE
F7
F9
F6
HI
LO
• The installation and repairing procedures should always carried out by the Authorised Service
Agent in order to avoid possible risks. The manufacturer shall not be held liable for damages that
may arise from procedures carried out by unauthorised persons. Repairs may be carried out by
technicians only. If a component has to be replaced, ensure that only original spare parts are used.
• Improper repairs or use of non-original spare parts may cause considerable damage and put the
user at considerable risk.
• Contact information for your customer service can be found on the back of this document.
• Function-relevant genuine spare parts according to the corresponding Ecodesign order
can be obtained from Customer Service for a period of at least 10 years from the date
on which your appliance was placed on the market within the European Economic Area.
Water inlet failure
Insufficient water
Continuous water input
Inability to discharge water
Heater error
Overflow
Faulty electronic card
Overheating error
Divisor position error
Faulty heater sensor
High voltage failure
Low voltage failure
Customer service
PL: +48 22 243 70 00
Mon 7:00 - 17:00
Tue-Fri 9:00 - 17:00
kontakt@kernau.com
WHAT TO DO
Make sure the water inlet tap is open and water
is flowing.
Separate the inlet hose from the tap and clean
the filter of the hose.
Contact for service if the error continues..
Contact for service.
Close the tap and contact for service.
Water discharge hose and filters may be clogged.
Cancel the program. If the error continues,
contact for service.
Contact for service.
Unplug the machine and close the tap. Contact
for service.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
EN
51