Filling The Rinse-Aid And Setting - Kernau KDI 6542 User Manual

WARNING:
If, along with the use of this type of detergent, you encounter any problem that was not there before, please
contact the detergent manufacturer directly.
Stop using combi detergents:
• Fill the salt and rinse aid container.
• Adjust the water hardness level setting to the highest position and carry out the washing cycle without
loading the dishes.
• Set the water hardness level.
• Adjust the rinse aid settings.
RINSE-AID USAGE
Rinse-aid makes dishes sparkle and helps them to dry without spotting. Rinse-aid is required for stain-free
utensils and clear glasses. Use only rinse-aid for domestic dishwashers.

FILLING THE RINSE-AID AND SETTING

To fill the rinse aid compartment, open the rinse-aid compartment cap. Fill the compartment with rinse aid to
the MAX level and then close the cap. Be careful not to overfill the rinse aid compartment and wipe up any
spills.
In order to change the rinse aid level, follow the below steps before turning on the machine:
• Push the programme button and hold it down.
• Turn on the machine.
• Hold down the programme button until "rA" disappears from the display. Rinse aid set follows water
hardness set.
• The machine will display the current setting.
• Change level by pushing the programme button.
• Switch off the machine to save the setting.
• The factory setting is "4".
• If the dishes are not drying properly or are spotted,
increase the level. If blue stains form on your dishes,
decrease the level.
LEVEL
1
2
3
4
5
BRIGHTENER DOSE
Rinse-aid not dispensed
1 dose is dispensed
2 dose is dispensed
3 dose is dispensed
4 dose is dispensed
INDICATOR
R1 is shown on the display.
R2 is shown on the display.
R3 is shown on the display.
R4 is shown on the display.
R5 is shown on the display.
EN
41