Vatech EzRay Air Wall VEX-S300W Installation Manual page 7

EzRay Air Wall (VEX-S300W) Installation Manual
 It is critical that installers read and understand the
installation instructions fully before installation.
 The installer must install the system according to the
instructions provided by this manual and perform the
appropriate procedures.
If the equipment has been stored at temperatures of

below10℃ (50℉) for more than a couple of hours, allow
the equipment to reach room temperature before
applying mains voltage.
People authorized by VATECH must only perform

installation and related work.
Do not connect any items or equipment to this system,

which are not part of the system: IEC60601-1-1.
Any equipment not approved by VATECH must comply

with the applicable standards: IEC 60950-1 for IT
equipment (ex: PC) and IEC 60601-1 for medical
electrical equipment.
All operators of this equipment are responsible for

ensuring that the requirements outlined in IEC 60601-1-
1: Safety Requirements for Medical Electrical
Equipment are fully met to ensure the safety of patients,
operators and the environment.
Use an ESD (electrostatic sensitive device) wristband

during installation and connect it to a ground wire.
Touch a ground point to discharge static electricity

before handling PCB boards.
Conventions Used in this Guide
iii