Alarm In - D-Link JustConnect DNR-4020-16P User Manual

Section 3 - Configuration
Use this page to enable an alarm when a signal from an external device connected
to the NVR's Alarm In interface is detected.

Alarm In

Select the channel to configure.
Enable Alarm
Toggle this to enable or disable Alarm In events and alarms.
In
Event Actions
Select the event(s) the alarm should trigger from the following
list:
• Email: Send an email notification
• Buzzer: Trigger a buzzer sound
• Popup Message: Display a notification in a popup window
Enable Alarm
Trigger a notification on the Alarm Out interface(s).
Out
Enable Event
Toggle to keep a record of alarm events.
Recording
Detection
Enable or disable the alarm according to a particular schedule.
Schedule
Normal State
Specify the normal state of the sensor. A change from this state will
trigger the alarm.
Port Name
Designate a name for the sensor.
Camera Alarm
Click this tab to configure similar settings for sensors connected to
In
a camera's Alarm In interface.
D-Link DNR-4020-16P User Manual
Alarm In
117