Angelo Po 0G1PE2 Use And Installation Manual page 31

ASSEMBLY APPLIANCES IN BANKS
To assemble appliances in banks (side by side)
proceed as described below.
1 - Undo the screws and remove the control panels
(B).
2 - Apply masking tape to the edges to be placed
side by side.
3 - Apply food-approved sealant to the edges to be
placed side by side.
4 - Place the appliances side by side.
5 - Connect the appliance using the screws and
nuts (C-D).
6 - Remove the excess sealant and the masking
tape.
7 - Apply the sealant to the inside of the lid (A), and
fit it to cover the fixing zone.
8 - Replace the control panels (B) on completion of
the operation.
ELECTRICAL CONNECTION (0G1PE2 - 1G1PE2)
Important
The connection must be made by author-
ised, skilled personnel, in accordance with
the relevant legal requirements, using ap-
propriate and specified materials. The ap-
pliance is supplied with operating voltage
400V/3N, which cannot be switched to other
values (see attached wiring diagrams).
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
Connect the appliance to the mains electricity sup-
ply as follows.
1 - If not already present, install a circuit-breaker
(A) with overload cutout and differential safety
breaker close to the appliance.
2 - Undo the screws (C) and remove the control
panel (B).
B
C
A
B
C
3 - Connect the circuit-breaker (A) to the terminal
board (D) of the appliance as shown in the dia-
gram and in the electrical system diagram at
the back of the manual. Use a cable with at
least H05RN-F characteristics.
Important
When connecting, take care to connect the
neutral and earth lines.
4 - Replace the control panel (B) on completion of
the operation.
- 13 -
A
D
IDM-39613301300.tif
IDM-39613300800.tif
IT
GB
D
DE
FR
ES
English